Thingiverse
Buzzsaw Vase
von caseyjholmes
63
Downloads
60
Likes
0
Makes
Buzzsaw vase, custom made by myself. 7 1/4" tall.
Use "Vase Mode" in your slicer to obtain the proper printing method to print this vase. Otherwise it is too thick and uses too much material. If you are using Cura, use "Spiral Countour" and set infill to 0% to get desired effect. Set bottom layers to 1.2mm. If you are using .2mm layers, this is a six layer bottom. Should hold water if you do it properly.
Looks better when printed in person than that photos do it justice. Top is small. Base is large. Photos look funny.
Buzzsaw shape. over 2" in Diameter. Flat base for stability. Use PLA, ABS, PETG, TPU or whatever you have... dry your filament in the oven first before printing for no bubble no leak finish. Trust me on that one.
Designed with Fusion 360 by yours truly.
Enjoy!
-Casey
Use "Vase Mode" in your slicer to obtain the proper printing method to print this vase. Otherwise it is too thick and uses too much material. If you are using Cura, use "Spiral Countour" and set infill to 0% to get desired effect. Set bottom layers to 1.2mm. If you are using .2mm layers, this is a six layer bottom. Should hold water if you do it properly.
Looks better when printed in person than that photos do it justice. Top is small. Base is large. Photos look funny.
Buzzsaw shape. over 2" in Diameter. Flat base for stability. Use PLA, ABS, PETG, TPU or whatever you have... dry your filament in the oven first before printing for no bubble no leak finish. Trust me on that one.
Designed with Fusion 360 by yours truly.
Enjoy!
-Casey
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!