Thingiverse
Electronics
Go to Model
C.H.I.P case
41
Downloads
46
Likes
0
Makes
Inspired from http://www.thingiverse.com/thing:1050735 but completely redrawn.
That's it !
it's working perfectly for me.
Please, share your prints !
Just be aware that "Boite Pocketchip battery v2" need to be printed on his side.
Once printed, you need to cutter cut the thin border. it is used as a support. It's thin enough to hold the piece and thin enough to be easily cut.
My prefered one is the "Boite Pocketchip battery v2" as it can hold a battery with it.
With a (very old) 1000Ma battery, i could make it run more than 2 hour. it was working as a Wifi Access Point + captive Portal.
That's it !
it's working perfectly for me.
Please, share your prints !
Just be aware that "Boite Pocketchip battery v2" need to be printed on his side.
Once printed, you need to cutter cut the thin border. it is used as a support. It's thin enough to hold the piece and thin enough to be easily cut.
My prefered one is the "Boite Pocketchip battery v2" as it can hold a battery with it.
With a (very old) 1000Ma battery, i could make it run more than 2 hour. it was working as a Wifi Access Point + captive Portal.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
