C270-GoPro-Adapter
door Horex1200
1
Downloads
3
Likes
0
Makes
Hello,
i would like to mount my C270 (Logitech) to my Ender 5. So i used a clamp with a flexible arm. But the problem was the connection between the flexible arm and the C270.
So i dismounted the basement of the cam and designed a adapter-plate. This plate can be clicked into the GoPro-Slide-In-Plate of the flexarm and on the other side the C270 is mounted via one simple screw (M3x30mm + (lock-)-nut).
The fit in the slide-in-plate is not super strong, but is could not fall out of this plate.
On the other side, there are two blocks PLA (i printed in PLA) with a hole (printed 2,7 mm). You have to drill it up to 3mm very carefully.
This project hat the state WORK IN PROGESS !!!
i would like to mount my C270 (Logitech) to my Ender 5. So i used a clamp with a flexible arm. But the problem was the connection between the flexible arm and the C270.
So i dismounted the basement of the cam and designed a adapter-plate. This plate can be clicked into the GoPro-Slide-In-Plate of the flexarm and on the other side the C270 is mounted via one simple screw (M3x30mm + (lock-)-nut).
The fit in the slide-in-plate is not super strong, but is could not fall out of this plate.
On the other side, there are two blocks PLA (i printed in PLA) with a hole (printed 2,7 mm). You have to drill it up to 3mm very carefully.
This project hat the state WORK IN PROGESS !!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!