Thingiverse
C270 VESA Mount
von pitachu
4
Downloads
4
Likes
0
Makes
I got new monitors with no bezel around the screen so the c270 overlapped the top of teh screen when mounted.
I put together this 'arm' to extend from the VESA mount to just above the screen on my 24" monitor.
Its nice and thick (8mm) because the first one I made (3mm) was too wobbly and video calls looked like the Enterprise was under attack.
All the 'fancy' shapes are to remove as much filament as I could.
*VERSION 2!*
Sometimes you get all caught up in the way you're doing something and don't realise there is a much more simple way. Version 2 of the bracket is much less fancy, uses less filament and prints faster.
I put together this 'arm' to extend from the VESA mount to just above the screen on my 24" monitor.
Its nice and thick (8mm) because the first one I made (3mm) was too wobbly and video calls looked like the Enterprise was under attack.
All the 'fancy' shapes are to remove as much filament as I could.
*VERSION 2!*
Sometimes you get all caught up in the way you're doing something and don't realise there is a much more simple way. Version 2 of the bracket is much less fancy, uses less filament and prints faster.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
