Thingiverse
C3 Corvette LED reverse light mount
by Smadoo
11
Downloads
7
Likes
0
Makes
This is an LED mount for aftermarket reverse lights ([Available Here](https://www.amazon.com/gp/product/B01LYHD6RC/)).
Mounting holes for the LED bar are sized for M3 screws / nuts.
The hole in the center is for running the cable through. I recommend filling the void with silicone sealant to prevent moisture issues.
The bracket slides over a piece of frame near the spare tire carrier, and is secured with two 12mm magnets ([Available Here](https://www.apexmagnets.com/magnets/12mm-x-3mm-disc-neodymium-magnet)). There is a pair of indentations inside the slot that the magnets can be glued into place
The positioning of these brackets is near the mufflers on a c3 Corvette, but it should be far enough away to avoid any melting issues, but I recommend printing in at least petg, if not something more heat resistant.
Mounting holes for the LED bar are sized for M3 screws / nuts.
The hole in the center is for running the cable through. I recommend filling the void with silicone sealant to prevent moisture issues.
The bracket slides over a piece of frame near the spare tire carrier, and is secured with two 12mm magnets ([Available Here](https://www.apexmagnets.com/magnets/12mm-x-3mm-disc-neodymium-magnet)). There is a pair of indentations inside the slot that the magnets can be glued into place
The positioning of these brackets is near the mufflers on a c3 Corvette, but it should be far enough away to avoid any melting issues, but I recommend printing in at least petg, if not something more heat resistant.
Smadoo also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
