C6 Corvette Lower Radiator Core Support Cap

This is a part that i made for a C6 Corvette Lower Radiator Core Support Skid Bar Plate for the Chinese knockoffs of the OEM ones that don't include a cap at the end of the piece of metal allowing water and dirt to get in. Takes about 20 minutes to print. I printed it in ABS black because of how much more durable it is than PLA and the higher heat tolerance (it is going in a corvette after all). Its a snug fit I made it slightly oversized so it doesn't come out. just whack it in. It printed with no issues on the P1S, I would clean the build plate with IPA and then allow your chamber to preheat for 30 minutes at 100C BEFORE you print.