C64 Power Supply Brick

This is a 3d Modeled enclosure to have a similar look to the original Commodore 64 Power Supply Brick. Since the original power supplies have issues with increasing voltage on the 5VDC line and are recommended not to use, I opted to make my own. I created separate brackets that can be glued to the base to hold the transformer and the 5VDC board. This allows any positioning you would want. The case is held together with friction fit and a few dabs of glue. It's big. Probably bigger than the original, but I wanted to make sure I had enough room for everything. This should easily house any alternative components to the AC transformer and 5VDC power supply board I used. The Top part of the enclosure will need to have supports. I used regular supports instead of trees. The Transformer is a Jameco Reliapro 9VAC 1500mA that can easily be found on electronics websites or Amazon. The 5VDC 2A board I pulled out of an old wall wart adapter I had laying around. You'll have to source your o