Thingiverse

Cable Bundle Clamps

by MaxWondercorn

39 Downloads

27 Likes

0 Makes

The clamping mechanism I designed to support the wiring bundle on my 3D printer wasn't holding up, so I designed this upgraded bundle clamp.

The clamp comes in 3 diameters - 14, 18, and 20 mm to hold a range of bundle sizes. I found I needed a narrower base in another application so there are also 2 different base sizes. The standard base width is 18mm while the narrower base is 14mm wide. Unless you need the narrow base the standard base is recommended.

The STEP files are included for the standard base sizes.

bracket cable bundle cable clip cable guide cable holder cable management cable tie clamp Cobblebot v-rail wire bundle guide wire holder wiring wiring clamp wiring harness bracket cable bundle cable clip cable guide cable holder cable management cable tie clamp Cobblebot v-rail wire bundle guide wire holder wiring wiring clamp wiring harness

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format