Cable chain attachment-ender 3 Direct drive

For use with "ModelStation" "Cable Chain" thing:11978.

I used this on my modified ender 3 pro. Due to the direct drive moving the extruder cable, and discarding the bowden tube. I had the hot end cable and the extruder cable dangling. using these brackets, the bottom one attaches to the underside of the center rail and extends just past the rear most stepper motor(Y Stepper). while the upper bracket attaches to the back of the cross rail(x axis) that the hot end travels left and right on. I used 36 of the Cable chain links and acheived a desired length to allow full travel. along with the attachment ends

will need:
8- M3*8 bolts
6-M3 T-nuts
2-M3*30 bolts(alternatively 4-M3*8 and 2 more M3 nuts)
4-M3 nuts

use the M3*30 to attach the bottom bracket the attachment end of the cable chain(thing 11978).

M3*8 bolts everywhere else