Thingiverse
cable chain
by blairq
13
Downloads
14
Likes
0
Makes
a 20mm cable chain , open at the top. put a 1.755 filament there. can be printed assembled if u are a real man.
needs to be printed in groups of 4 twisted 90 degrees each. like in the picture. print shitloads of them. fine tune your printer before ... ehm.. printing them. otherwise is a p.i.t.a. sand every one of them (as i did)
needs to be printed in groups of 4 twisted 90 degrees each. like in the picture. print shitloads of them. fine tune your printer before ... ehm.. printing them. otherwise is a p.i.t.a. sand every one of them (as i did)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
