Thingiverse
Cable Channel Set TypeA
von titoBLN
67
Downloads
53
Likes
0
Makes
Cable channel set TypeA - customized on your room - plug them together.
1. Print the cover elements with spiral print mode or single-wall with no infill (spiral print with 0 or 1 bottomlayer)
2. Fit the cover elements together in the right order and check the route.
2. Cut or drill out the cable entries on side and holes for wall mounting backside
3. Plug the elements together and mount the system
My settings:
-0 or 1 bottom layer
-spiral mode
-0,4mm nozzle
-0,2mm layer high
1. Print the cover elements with spiral print mode or single-wall with no infill (spiral print with 0 or 1 bottomlayer)
2. Fit the cover elements together in the right order and check the route.
2. Cut or drill out the cable entries on side and holes for wall mounting backside
3. Plug the elements together and mount the system
My settings:
-0 or 1 bottom layer
-spiral mode
-0,4mm nozzle
-0,2mm layer high
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
