Thingiverse

Cable Clamp 2020

von henryarnold

281 Downloads

131 Likes

0 Makes

Originally I had my extruder cable bundle tied to the frame using a large wire tie. This clamp is neater and holds the cable in place better. This clamp can be used for any cable needing to be attached to an aluminum extrusion. The cradle is 12 mm across and the mounting holes are 5 mm. Its hard to see in the photos but there is a path under the cradle for the wire tie to pass through. The path allows for up to a 6 mm wide x 2.5 mm thick wire tie.

This is my HyperCube printer:
http://www.thingiverse.com/make:272257

2020 2020 extrusion 2020 mount aluminum extrusion cable cable clamp cable clip cable holder cable management clamp corexy Extruded Aluminum Extruder cable hypercube

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat