Cable clamp OpenSCAD parametric

Made this for a friend. Simple design, almost everything is resizeable to fill your needs.
V1.1: Adjusted the cable inlet angle so the cables snap in easier.
V2: Now I understood how this thing works ;-) Just measure the diameter of your cable and count the loops you want it to hold, that's all. For several reasons you should add a small value to your diameter to make the cable snap in easy but don't fall out too easy. Depends on the diameter, material used, and your printer.
If you have something with 2 different cables attached, like my notebook power supply at the photo, you may combine 2 different clips.