Slicer Discord
Cable gland PG7 wall mounts – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

Cable gland PG7 wall mounts

63 Downloads
28 Likes
25 Makes
Zum Modell
The model was created from the need to run cables from the solar system to the inside of the car. It will be perfect for caravans, campers and other places where a waterproof cable passage through the wall will be needed. The model has dedicated 4mm holes for screws/bolts with a countersunk head. When assembling, consider the location of this housing so that there are no shelves where water can accumulate. The bottom of the housing and bolt holes should be sealed with a special sealant, e.g. Sikaflex 252 or similar. Due to the outdoor use, I recommend printing this model from ASA or other material resistant to large temperature differences and UV.
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ASA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Bartek Zalewski veröffentlicht auch auf

7 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen