Cable Guide and Fan Grill

This is a very useful design, acts both as a fan grill and cable guide keeping the Print head cables off the print bed and reducing the strain and flex on the cables at the extruder motor.

My remix changes the grill for a honeycomb pattern and if you like, it can be printed in 2 parts in different colours and then press fit together as I have done. (I Also used a few dabs of superglue)

The fan grill can be used with a fan shroud and can be fit over the cables without disconnecting them. (My remix is a little easier to get the cables and sheathing into.

Lastly tighten a cable tie around the cable guide to secure everything.