Thingiverse
Cable Guide for Ender 3 (Direct Drive)
door stries
4
Downloads
12
Likes
0
Makes
*Print the holder vertically, not horizontally
I found out that my Ender 3 Pro printer direct drive wire was very long, thus it crosses over the print area. Hence, I came up with a minimalistic holder that guides the direct drive wire through at the back where the extruder motor used to be.
Items required:
2x M3 Screws
I found out that my Ender 3 Pro printer direct drive wire was very long, thus it crosses over the print area. Hence, I came up with a minimalistic holder that guides the direct drive wire through at the back where the extruder motor used to be.
Items required:
2x M3 Screws
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!