Thingiverse
Cable Holder for Drawer Customizable
door joergp
18
Downloads
7
Likes
0
Makes
The purpose of the cable holder is to hold the cables firmly in place at the back of a drawer. My USB power adapter is located in a second drawer below this drawer.
Use OpenSCAD to edit all parameters and adjust to your needs. If you use a remix with screw hole, make sure to put the thinnest cable in the middle and the thicker ones to the outside. it may be better to have two cable holders positioned at the outer edges so cables are distributed to the left and the right of the drawer.
Use OpenSCAD to edit all parameters and adjust to your needs. If you use a remix with screw hole, make sure to put the thinnest cable in the middle and the thicker ones to the outside. it may be better to have two cable holders positioned at the outer edges so cables are distributed to the left and the right of the drawer.
joergp publiceert ook op
20 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
