Thingiverse
Cable Holder/Stopper
2
Downloads
1
Likes
0
Makes
This is a cable holder/stopper for 6mm diameter cables.
*NOTE: A 3mm threaded insert is needed to complete the part.*
-Desinged Dimentions:
Main Hole Dia. - 6.4mm
Side Hole Dia. - 4.8mm
Small Outer Dia. - 14mm
Large Outer Dia. - 16mm
Height - 20mm
*Actual dimentions may vary due to plastic attributes.
-Build & Use Instructions:
Aquire a 3mm threaded insert (you can use lager sizes but this fits better with the model)
Print your cable stopper
After printing heat up and press fit the thread insert in the side hole (Soldering Iron works best)
Pass the cable through the large main hole
Screw a M3 (3mm Dia) screw on the side. (Don't screw too tight or you may drill into your cable and cause shortcircuit)
*NOTE: A 3mm threaded insert is needed to complete the part.*
-Desinged Dimentions:
Main Hole Dia. - 6.4mm
Side Hole Dia. - 4.8mm
Small Outer Dia. - 14mm
Large Outer Dia. - 16mm
Height - 20mm
*Actual dimentions may vary due to plastic attributes.
-Build & Use Instructions:
Aquire a 3mm threaded insert (you can use lager sizes but this fits better with the model)
Print your cable stopper
After printing heat up and press fit the thread insert in the side hole (Soldering Iron works best)
Pass the cable through the large main hole
Screw a M3 (3mm Dia) screw on the side. (Don't screw too tight or you may drill into your cable and cause shortcircuit)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
