Thingiverse
Cable holder
von stiganielsen
8
Downloads
4
Likes
0
Makes
The cable its made for is Ø9mm and it holds 6 cables very close together. For the hinge pin I used a Ø2mm bikespoke. One side is a hinge, the other is a split for closing. One of the halves have screwholes for mounting. I guess one could just scale the .stl for different size wires and then use thinner netal wire for the hinge and split.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
