Thingiverse
Cable Management for modular 19" 2U System
von NPetersen
2
Downloads
1
Likes
0
Makes
I created this design for the Raspberry Pi Modular 19" 2U rack design Krapozok did here: https://www.thingiverse.com/thing:1793758
The reasoning for it is that my rack is an open rack, at floor height (12U), and all my devices in this modular design has USB's sticking out of it. So to make sure that some plastic break instead of a possible bent USB-Port if some one will hit into it. This was the solution i came up with.
So it helps with two things
- Cable Management
- Making sure you break the plastic and not the USB ports of you hit it,
Installation:
Put this over the thing you wanna screw down and screw both things into the plate at once.
The reasoning for it is that my rack is an open rack, at floor height (12U), and all my devices in this modular design has USB's sticking out of it. So to make sure that some plastic break instead of a possible bent USB-Port if some one will hit into it. This was the solution i came up with.
So it helps with two things
- Cable Management
- Making sure you break the plastic and not the USB ports of you hit it,
Installation:
Put this over the thing you wanna screw down and screw both things into the plate at once.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
