Cable management - Ribbon + Other

I needed to tidy up the cables on my Geeetech Prusa i3 B, even after shortening them. The ribbon cables was the worst offender and I wanted a clip that could hold them in place, but I also wanted to manage the stepper motor and other cables. So I made a cut out on the other side to route them in.

I printed them without infill a few top and bottom layers and three perimeters.

See http://www.thingiverse.com/thing:1761901 for more information about how I routed my cables.

Print a few and get those cable in order. Start with one to make sure it fits and holds the cables in place and scale as needed.