Thingiverse
Cable management?
door aCreativeCurse
22
Downloads
24
Likes
0
Makes
Need an excuse to use your 3d printer(s) to solve a minor problem? Then I have the solution for you.
That said these cable ties are still relatively cost-effective and a very robust solution.
The designs revolved around the idea of a robust solution that could hold many wires securely and could be rewired indefinitely with as little effort as possible.
To make the system you will need some kind of pin, I used a large safety pin. I took inspiration from buses on circuit boards.
That's why I mad a bigger version of the loop part. I used them to use up the extra length in my wires to make the whole system look cleaner.
I could easily print 6 at a time on my CR-10S but your results may vary.
As always feel free to modify to your needs.
That said these cable ties are still relatively cost-effective and a very robust solution.
The designs revolved around the idea of a robust solution that could hold many wires securely and could be rewired indefinitely with as little effort as possible.
To make the system you will need some kind of pin, I used a large safety pin. I took inspiration from buses on circuit boards.
That's why I mad a bigger version of the loop part. I used them to use up the extra length in my wires to make the whole system look cleaner.
I could easily print 6 at a time on my CR-10S but your results may vary.
As always feel free to modify to your needs.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
