MakerWorld
Organizers
Go to Model
Cable Organizer
37
Downloads
5
Likes
25
Makes
3D MODEL DESCRIPTIONIntroducing the cable organizer. a practical way to organize all of your cable🙂3D PRINTING SETTINGS• Layer Height 0.2mm• No supports needed• Nozzle 0.4mm• Recommended infill 10%.• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.• Make sure your bed is correctly leveled.• Make sure your printing temperature and bed temperature is adequate for the filament you are about to us
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
