Thingiverse
Cable spool organizer
von Ukuku
3
Downloads
10
Likes
0
Makes
Tool to spool your USB (or similar) cables.
Just put your cable through the side holes on the bottom shell, pull around halfway then close with the top shell.
Rotate to spool the cable.
I printed mine with PETG @18% infill, 3 wall loops. Should work fine with PLA too.
Just put your cable through the side holes on the bottom shell, pull around halfway then close with the top shell.
Rotate to spool the cable.
I printed mine with PETG @18% infill, 3 wall loops. Should work fine with PLA too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!