Thingiverse
Cable Spool (Print in Place)
di Fork501
7
Download
0
Likes
0
Makes
This is a print-in-place cable spool. It should fit USB-C, Micro USB or Lightning Cables, at a minimum.
Print this with rafts/scaffolds and when it finishes, there is no assembly required. Just remove the rafts and you're all ready!
To use, feed a cable through the outside hole and through the hole on the spool, then twist the lever. Make sure your cable is lined up in the middle as best as you can, then it will pull both ends through the holes and it should stay in place.
Print this with rafts/scaffolds and when it finishes, there is no assembly required. Just remove the rafts and you're all ready!
To use, feed a cable through the outside hole and through the hole on the spool, then twist the lever. Make sure your cable is lined up in the middle as best as you can, then it will pull both ends through the holes and it should stay in place.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
