CableCritter for Desktop Cable Grommets

About the modelIt is basically a cable holder for an existing cable duct on the desk. It is attached from below with a few small wood screws. The cable is then threaded first through the inner ring and then through one of the slots in the middle plate. The whole thing is then assembled by screwing the inner ring onto the mounted outer ring. The slots are designed for cables up to 5 mm thick. This also means that any plug thicker than this will not slip through. The straight piece is so that it can be mounted closer to obstacles or the edge of the table. I use it for my charging cables, which until now have either always slipped through and sent me on a fishing trip or have been lying around disorganized on my desk. Printing parametersNot much to say here. The default parameters worked out of the box for me, but I used the 0.16mm preset, as I thought it would be better for the threads. About my deskYes, it looks basically like swiss cheese. I like to try things out and normally no one i