Thingiverse
Cactus Stand
by Burrel87
15
Downloads
18
Likes
0
Makes
To prevent my cacti from tipping over, I designed this stand.
Ring diameter is 51mm, top height is 53mm.
Flip it up side down for printing, no supports needed, angle is less then 45degrees.
Scale up the diameter to fit your pot diameter and scale up the height so the pot is raised up a bit and not resting on the surface you place it on.
Ring diameter is 51mm, top height is 53mm.
Flip it up side down for printing, no supports needed, angle is less then 45degrees.
Scale up the diameter to fit your pot diameter and scale up the height so the pot is raised up a bit and not resting on the surface you place it on.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
