Thingiverse
CAD coin carrying case
door mig_318
14
Downloads
21
Likes
0
Makes
Coin carrying case the Case is approximately the size of a credit card, carries somehwere close to $11CAD in change (3 toonies 3 loonies 4 quarters, 6 dimes 4 nickels).
The mechanism that keeps the case closed when in your pocket is mostly through a friction fit between the exposed coin edges and the inner plastic walls of the outer sleeve. The coins are able to rotate somewhat freely and act almost like wheels allowing deployment with a small to medium force depending on actual dimensions after printing.
there is a small dimple that lines up with the slot on the outer casing to make it easy to slide the container out. Once out the coins can be pulled out rather easily by the gap at the edges of the case or a finger can be pushed in from beneath the coins to make it easier to get access to them. The mechanism to open the case will need to be used a few dozen times to shave down whatever plastic might be in the way after which the mechanism is somewhat smooth.
The mechanism that keeps the case closed when in your pocket is mostly through a friction fit between the exposed coin edges and the inner plastic walls of the outer sleeve. The coins are able to rotate somewhat freely and act almost like wheels allowing deployment with a small to medium force depending on actual dimensions after printing.
there is a small dimple that lines up with the slot on the outer casing to make it easy to slide the container out. Once out the coins can be pulled out rather easily by the gap at the edges of the case or a finger can be pushed in from beneath the coins to make it easier to get access to them. The mechanism to open the case will need to be used a few dozen times to shave down whatever plastic might be in the way after which the mechanism is somewhat smooth.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!