Thingiverse
Calabridget Spinner Mark 0
von LostHawken
1
Downloads
4
Likes
0
Makes
Calibridget Spinner is a fun test I designed to test the resolution of my 3D printer. It will never roll as nicely as a spinner with bearings; metal or printed, but it will be a fun fidgnet toy once printed, and tell you some things about your printer.
Each section has gaps, ridges, grooves, and overhangs that decrease in size as each ring gets smaller and are labelled on each ring.
On my runs when I was still setting up my Ender 3, I could only get the ball to break free and spin at 1, and 0.6mm. Future iterations of this design will have less dramatic decreases in ball/ring size which will hopefully improve the chance of a successful build of the sections below 0.4mm
Supports are a must, but only from the build plate up, and minimze them as much as possible to make post-processing easier.
Each section has gaps, ridges, grooves, and overhangs that decrease in size as each ring gets smaller and are labelled on each ring.
On my runs when I was still setting up my Ender 3, I could only get the ball to break free and spin at 1, and 0.6mm. Future iterations of this design will have less dramatic decreases in ball/ring size which will hopefully improve the chance of a successful build of the sections below 0.4mm
Supports are a must, but only from the build plate up, and minimze them as much as possible to make post-processing easier.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
