Caldera - Marble board game

Caldera - A Marble Race Board Game --Recommended Print SettingsPrinter: Bambu Lab P1S (tested)AMS: Bambu Lab Automatic Material SystemLayer height: 0.2Infill: 4%Supports: NoneFilament: PLAPrint time: ~7 hoursNotesColor swaps occur at layer height, so only 4 filament changes during print.Board prints without supports.Standard 14–16mm marbles work well. Colors used: Blue, Green, Black, and WhiteColor changes are triggered by layer height (check preview), so there are only 4 color swaps, keeping the total print time down to about 7 hours. A second plate is included containing four marbles.A 6-sided die is required but not included, since most players already have one.Board DesignThe game board was loosely inspired by Mount Fuji.I went through a few iterations (as seen below), adjusting the Volcano size, tunnel size, and many other various tweaks until i settled on the curent design. Game Rules (Work in Progress)The rules are still being tested, so feedback is welcome!So far the game has o