Caldwell Brass Catch Mount

This is for the Caldwell Brass Catcher that attaches to the picatinny rail. I needed a spare mount and couldn't get one without buying another brass catcher. This is designed using the actual picatinny specs. if your printer is not tuned correctly it will not fit the brass catcher. The clamp is a separate piece so make sure to separate them in your slicer.

Support is needed for the bolt hole only. Print this vertically. Uses an M4x30 Bolt. If you are taking on and off a lot use the Brass Catch Insert Clamp. This one uses M4 Short Heat Stake insert.

2/8/25
Added one piece print and is already orientated to proper printing position. It contains built in support. WARNING, your printer must be calibrated to within .1mm printing accuracy. If it does not slide on you have over extrusion/print dimension accuracy issues. If it is sloppy you have under extrusion/print dimension accuracy. It MUST be printed at .1 layer height .2 layer height it will not slide on or be very tight. Tested wit