Calibration cube paint No support

by Mick23 · Sculptures

62 Downloads

33 Likes

17 Makes

Hi, here a little model of calibration cubeIt print Flat with no supports, When its printed, draw imaginaire dot lines on calibration cube paint.Its between these right dotlines you need to heat with a lighter underneath, back and forth until the temperature is just above 65 degrees. Now you can fold it over and push on it to a corner of a table or shelf. When it is cool down, you can heat between the other imaginary dot lines. And repeat the previous steps If you have any problem , let me know Look also my benchy paint Benchy paint NO SUPPORT by Mick23 - MakerWorld <img src="https://makerworld.bblmw.com/maker