Calibrix Danish Block Stud Calibration Tool

This model is specifically for designers who design Danish blocks 3D printed parts to use to get the perfect stud size on their parts. Their studs tend to be less than forgiving when it comes to tolerances. Too loose is bad because the parts do not interlock well. Too tight is hard to press together and nearly impossible to pull apart. The Danish blocks company has tolerances within thousandths of a mm (absolutely insanely precise!), but we aren't going to hit that with a 3D printer – sorry. However, if you are trying to design a custom part, my tool allows you to figure out what the best size is for your specific printer within a hundredth of a mm. How to use: 1.) Print the model. 2.) Start near 2.4 mm (the standard radius of a Danish block stud) and see how well a real Danish block accepts your 3D printed stud. 3.) If too loose, move up to a higher number (2.41 mm), else if too tight, move down to a lower number (2.39 mm). 4.) Repeat trying studs until you find a perfect fit. How