Calypso Hull re-cut

REMIX: The ends of the original models hull sections were cut at varying angles which made them unnecessarily difficult for me to print. I personally would use the originals if I had water soluble supports or was printing other than FDM. I re-merged and re-cut the hull in order to create a single horizontal cut on all ends. This makes this a much easier print. Supports are still required but the ones on the edges of the hull are eliminated. These parts will not mix and match with the original parts 01-07 but will match to the rest of the model.

Printing revealed a fault in parts 05 and 06. The strakes in the original model are not merged with the hull and print separately. I have corrected this but would welcome anyone smoothing the join.

I printed at 150%