Thingiverse
Cam for draft excluder
door iborg
2
Downloads
0
Likes
0
Makes
Hi All
My first attempt at drawing and printing something.
This is a replacement cam (or knob) for one that broke on my garage door.
The screw goes through the hole (obviously!). The head of the screw should fit on the ridge.
I made the hole 4mm for the thread, 8mm for the screw head.
Check the hole sizes for your screws.
My first attempt at drawing and printing something.
This is a replacement cam (or knob) for one that broke on my garage door.
The screw goes through the hole (obviously!). The head of the screw should fit on the ridge.
I made the hole 4mm for the thread, 8mm for the screw head.
Check the hole sizes for your screws.
iborg publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!