CAM MOUNT TPU MOBLITE 7

Quadcopter Moblite7 liked its simplicity, minimum parts, good motors, light weight. But a lot had to change, but this applies to flights around the room. For the street, everything will be fine. Changed the camera mount. The standard mount is constantly knocked down, especially if you fly around the room. The new mount is printed with TPU plastic, it is fixed with a screw and is only suitable for the assembled quadcopter. For another frame, which is a spare one, another mount needs to be modeled there. The camera installation angle for the room is practically not needed, the speed is not so high there. But for racing, you can also tilt the camera. The flight controller settings are also not very suitable for flying around the room, because if you touch an obstacle, the quadcopter bounces strongly, control is lost, and it takes a long time to recover. I found the settings on the site https://oscarliang.com/flash-betaflight-moblite-6-7/, there, in the comments, MATTI offers settings for