Camber adjustment HUDY

The HUDY tire truer has a little bit of adjustment to the camber of your tire, but not enough for the rubber tires we run on our BRM 1/24 cars.
So i made this thing to fix that.
It has the same geometry as the original part but has a adjustable upper part to fine tune your camber when you are trueing your tires.
You will need a m4x20 cylindric head bolt and some other m4 bolts of your choice ,for the pressure screw you can use the originale finger screw(mine was too short) , has to be around 25 mm long same as the stop screw , depending on your tire size.
The camber screw can be 15mm long , you dont need so much length just enough to move it a couple mm.
It is designed to use 2x 3x6x2.5 flange bearings (slot car size) in the top part and 2x bronze bearings of the same size in the bottom part , if you race BRM cars you have a lot of them or you can put ball bearings in it too.
You use a 3mm axle to hold it in place , around 64mm long , just file a flat spot at the end for the set screw.