Thingiverse
Camera 1/4 inch screw
von jonnor
164
Downloads
122
Likes
3
Makes
Printable 1/4" (quarter inch) screw, like used for typical camera mounts.
Marked work-in-progress because the square base is very uncomfortable for the fingers, and the printability is not ideal.
On my PrintrBot Simple wooden, worked best when printed at 95% scale. Must use 100% fill for strength, layer thickness
Marked work-in-progress because the square base is very uncomfortable for the fingers, and the printability is not ideal.
On my PrintrBot Simple wooden, worked best when printed at 95% scale. Must use 100% fill for strength, layer thickness
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
