Thingiverse
Camera holder UK65 US65 UR65
von DopeJohnny
68
Downloads
55
Likes
2
Makes
This new holder for the UR / UK / US65 FPV camera should keep it better in place. That will prevent it from creeping into the canopy on frontal crashes. I designed it similar to the original to keep the same look.
**Must be printed with flexible filament (TPU)!** Be careful to not rip the lens from the PCB when you (dis)mount the holder!
The cam sits a bit higher, so you probably need to do some customization to the hole in the canopy for the video antenna.
I also added the Fusion 360 source file, if you like to make any changes yourself.
Update 2019-01-22:
-made the overall body wider, so the camera angle stays better
-changed screw hole, so it has more bite
-changed the slot, so camera is easier to (dis)mount
**Must be printed with flexible filament (TPU)!** Be careful to not rip the lens from the PCB when you (dis)mount the holder!
The cam sits a bit higher, so you probably need to do some customization to the hole in the canopy for the video antenna.
I also added the Fusion 360 source file, if you like to make any changes yourself.
Update 2019-01-22:
-made the overall body wider, so the camera angle stays better
-changed screw hole, so it has more bite
-changed the slot, so camera is easier to (dis)mount
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
