Camera Lens Cap Instax Mini Evo

This is a lens cap for the popular instax mini evo hybrid camera from Fujifilm. I really liked the cap design for professional cameras, but couldn't find a 3D model of one, so I made my own. The cap is made of 2 parts, printed side by side. For assembly, use some super glue on the underside cutout on the fixed part, then pop the center pin of the moving part in, let it dry and that's it. I might try a glue-less assembly in V2, if it is requested. The part prints well without supports, however it can be a little rough around the edges, so you can reverse the fixed part and add supports if you want it to be smoother. The spring design of the moving part is a bit too rigid, but it does the trick. You can push it in if you put one side under the lens ring, squeeze it and push down on the other side. The release is much smoother, just squeeze and it should pop right out. The diameter of the cap is 44mm, matching the inner diameter of the mini evo. There is also a lip at the bottom o