Thingiverse
Camera Mount and Case Ender3 V2
von Fadetoblack72
9
Downloads
5
Likes
0
Makes
Redesigned the case for a smaller camera set-up. Check the included drawing for dimensions.
There is a Angled bracket for raising the camera a bit higher as well.
Requires The Following...
4-M3X16 Flat Head Screws
4-M3 Nuts
There is a Angled bracket for raising the camera a bit higher as well.
Requires The Following...
4-M3X16 Flat Head Screws
4-M3 Nuts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
