Camera Mount for OpenAstroTracker using Tripod Mount (SCAD)

UPDATED (5/14/20) - Combined all three files into one file
UPDATED (7/26/20) - Changed default tripod slot size to 6.4mm (rather than 5mm). Thanks to /u/BenJuan26 for the heads up. 1/4in to mm is about 6.4mm.

**I found that adding electrical tape to the mount where the camera would sit would help to prevent the camera from rotating around the mount as much.**

This is a SCAD version of the Canon 7D Camera mount for OpenAstroTracker by jeffcapeshop to the best of my abilities. Like the original design, this is mainly intended for individuals who have their center of gravity too close to the camera body to use the normal amount. Instead, it utilizes the tripod mount on the camera to interface with the OpenAstroTracker (https://www.thingiverse.com/thing:4167783)

This is my first time using SCAD so I commented as much as I could to reduce the confusion when reading the file. Most of the dimensions for this model were taken from jeffcapeshop Fusion 360 file. To compensate for this,