Thingiverse

Camera Mount for TAZ 6 with Raspberry Pi Camera Module V2

door cmadson

10 Downloads

9 Likes

0 Makes

I wanted a camera mount for the TAZ 6 that was mounted to the bed. I designed this one for the Raspberry Pi Camera Module V2. It prints in two pieces that snap under the bed and are secured by a cable tie at the same location on the print bed that you are supposed to secure the wires to anyway. It also provides a channel to run the ribbon cable from the RPi to the Camera. I had originally intended to make a cap but the camera module stays securely in place without one.

Attached are my .gcode and S3D .factory files. If you need any additional tips on printing please refer to them!

Bron

Thingiverse

Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid

Eendelig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 0/3

Printer

FDM / FFF

Bestandsformaat