Thingiverse
Camera Slider Motor Mount
door MRLNWBR
9
Downloads
5
Likes
0
Makes
You need:
Round Gearbox Motor: 37mm diametre
2x M4x15 screws and nuts for tensioning the belt
2x M2x10 for srewing the two parts together. They are not super important, the M4s hold it together too, but its more durable with the two M2s.
This is a work in progress. I'm not 100% happy with the couple of mm that the "Slider Part" is pushed on the rail. But the feet of my slider do not allow more. I may come up with a solution for that in the future.
Square Gearbox Motor
Screw holes: 19x33mm (part has slots for easier belt tensioning)
Gearbox width: 32-33mm
Mounting screws: 4x M3x8 (screw holes in the part are 5mm deep, 4mm go into the gearbox)
Round Gearbox Motor: 37mm diametre
2x M4x15 screws and nuts for tensioning the belt
2x M2x10 for srewing the two parts together. They are not super important, the M4s hold it together too, but its more durable with the two M2s.
This is a work in progress. I'm not 100% happy with the couple of mm that the "Slider Part" is pushed on the rail. But the feet of my slider do not allow more. I may come up with a solution for that in the future.
Square Gearbox Motor
Screw holes: 19x33mm (part has slots for easier belt tensioning)
Gearbox width: 32-33mm
Mounting screws: 4x M3x8 (screw holes in the part are 5mm deep, 4mm go into the gearbox)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
