Thingiverse
camera stabilizer gimbal
von netpipe
34
Downloads
29
Likes
0
Makes
camera stabilizer remixed from https://www.thingiverse.com/thing:672295
bearings were moved to outside to allow better tightening and assembly without zip ties.
bearings are 4x 625z.
1 inch bolts with dab of hotglue on end of threads or some locknuts, diy can be made with vice and hammer with a smack. also use a jet lighter on the plastic if you have issues with the center ring getting the bearings in.
https://www.thingiverse.com/thing:84142 used the camera mount from here and there are some video's of another similar setup.
newer videocamera's like the sony hdr-cx240 series iirc have an automatic stabilizer in it that is actually very nice already.
bearings were moved to outside to allow better tightening and assembly without zip ties.
bearings are 4x 625z.
1 inch bolts with dab of hotglue on end of threads or some locknuts, diy can be made with vice and hammer with a smack. also use a jet lighter on the plastic if you have issues with the center ring getting the bearings in.
https://www.thingiverse.com/thing:84142 used the camera mount from here and there are some video's of another similar setup.
newer videocamera's like the sony hdr-cx240 series iirc have an automatic stabilizer in it that is actually very nice already.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
