Thingiverse
Camera Trigger for taking octolapse like timelapses
von sbsoneji
2
Downloads
0
Likes
0
Makes
This is for direct drive extruder because extruder motor was colliding with switch in my older design so I made another design from scratch.
With this accessory, you can take amazing time-lapses like octoprint but with very very high quality if you connect it with a camera.
I used it with Ender 3V2 but it can also be used with Ender 3/3 Pro
Limit switch pusher fits on the nozzle head in the place of the ABL switch.
Switch mount main fits on X motor pulley cover.
There is space to adjust the gap for limit switch triggering.
To use it, add the code line to park the print head to X0 or the X switch triggering coordinate, Y200, or the bed limit and wait for some time to take the photo between all the layers.
EX:
G0 F8000 X05 Y200
M400
G4 P1750
Where F8000 is the feed rate, M400 is the code to wait for the moves to finish, G4 is the code to wait and P1750 is the code to wait for 1750 milliseconds if used with G4.
With this accessory, you can take amazing time-lapses like octoprint but with very very high quality if you connect it with a camera.
I used it with Ender 3V2 but it can also be used with Ender 3/3 Pro
Limit switch pusher fits on the nozzle head in the place of the ABL switch.
Switch mount main fits on X motor pulley cover.
There is space to adjust the gap for limit switch triggering.
To use it, add the code line to park the print head to X0 or the X switch triggering coordinate, Y200, or the bed limit and wait for some time to take the photo between all the layers.
EX:
G0 F8000 X05 Y200
M400
G4 P1750
Where F8000 is the feed rate, M400 is the code to wait for the moves to finish, G4 is the code to wait and P1750 is the code to wait for 1750 milliseconds if used with G4.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
