Thingiverse
CameraBuddyBear
door andimoto
3
Downloads
4
Likes
0
Makes
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/2XZOjs87hNn
My niece is a little bit afraid of bigger cameras. So I made a little bear to put on the lens. I hope this will take her mind off the camera. The hole diameter of this bear is 68mm. The SEL55F18 which I'm using for portraits has a diameter of 64mm. I used some foam between lens and bear to avoid scratching my lens with the plastic.
For colours I used simple break commands (filament changes). It is designed to enable multiple colours separated by layer height.
Complete model size is about 166mm x 154mm x 13mm. Printed on Original Prusa Mini
My niece is a little bit afraid of bigger cameras. So I made a little bear to put on the lens. I hope this will take her mind off the camera. The hole diameter of this bear is 68mm. The SEL55F18 which I'm using for portraits has a diameter of 64mm. I used some foam between lens and bear to avoid scratching my lens with the plastic.
For colours I used simple break commands (filament changes). It is designed to enable multiple colours separated by layer height.
Complete model size is about 166mm x 154mm x 13mm. Printed on Original Prusa Mini
andimoto publiceert ook op
60 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!