Thingiverse
Cameron's Raspberry Pi 3 Case
par ckc28
20
Téléchargements
8
Likes
0
Makes
This is my version of a case for the Raspberry Pi 3. I was inspired by a similar case (https://www.thingiverse.com/thing:604915), but wanted extra features. And, I just wanted to challenge myself with a design of my own.
Features:
Contoured design.
Friction fit - no fasteners or glue needed for assembly.
Access to all plugs, memory card and GPIO interface.
Two mounting flanges with slightly oversized holes for a #10 fastener.
RPI logo air vent.
World Map on underside - because science and technology is for everyone!
Print details:
> Approx 30g material and 2 hr print time.
> 2mm thick case design, requiring minimal infill.
> You can print with no infill if you make your first 8 layers solid fill.
> You can print this without supports if your machine can bridge over spans of an inch or so. Otherswise, use supports.
> Remember to 'union overlapping volumes' when slicing and making gcode.
> The case is designed to fit the electronics 'snugly'. Because of the tight tolera
Features:
Contoured design.
Friction fit - no fasteners or glue needed for assembly.
Access to all plugs, memory card and GPIO interface.
Two mounting flanges with slightly oversized holes for a #10 fastener.
RPI logo air vent.
World Map on underside - because science and technology is for everyone!
Print details:
> Approx 30g material and 2 hr print time.
> 2mm thick case design, requiring minimal infill.
> You can print with no infill if you make your first 8 layers solid fill.
> You can print this without supports if your machine can bridge over spans of an inch or so. Otherswise, use supports.
> Remember to 'union overlapping volumes' when slicing and making gcode.
> The case is designed to fit the electronics 'snugly'. Because of the tight tolera
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
