Camping Clamp

Hardware:4x m3*16 inset hex screw4x m3 nutsTighten bolts until the the grip is firm I suggest putting a small amount of machine oil or lithium grease on the areas where plastic rubs on plastic Tighten until you have reached your desired grip strength. Both jaws will stay at a consistent strength no matter which of the 2 bolts are tightened. Loctite threadlocker is optional; i prefer to not use it for future adjustability There are additional holes in the jaws to thread in a thin rope for a locked position. Do not over-tighten- especially if the orange part is PLA. Otherwise, the orange pins keeping the black gears in place, will deform too much, causing the opposite end (the side with no screws) of the orange part to separate, and the increase in diameter from the deformation will press up against the inside of the gears and seize the mechanism3mm hole on jaws (not the hole for the screw) Print AdviceI printed the jaws with 6 walls, 60% infill, and the body with ABS, 4 walls, 30% infil