Camping Cup Holder

Designed to prevent drinks and cans from tipping over on uneven terrain and easy to assemble and disassemble on the fly so it fits nicely into any bag or box without taking up too much space, by simply inserting its 3 prongs into soft ground will prevent accidental knocks leading to a loss of a refreshing drink. Printed from ABS preferably although PLA is still perfectly useable just not quite as strong.It can accommodate drinks and cans up to 80mm in diameter such as:350ml Cans (Standard coke/ Fanta Can)A bottle of CoronaMost standard glassesI would recommend scaling up or down depending on your specific needs. ASSEMBLY:Insert the leg on to the bottom side of the centre piece (side with holes), they only go on one way so don't worry about doing this step wrong. This will very likely not fit/ be very tight fit so please refer to the IMPORTANT NOTE below: IMPORTANT NOTE:Once printed Sand the tops of the ‘T’ part until it fits but not too loose and insert the prongs into the slot a c